Slinging & Rigging VR training for steel in Bengaluru.

DrillXR Slinging and Rigging trains slingers and riggers to secure a load correctly in a virtual yard, where a misjudged weight or a badly rigged sling teaches a lesson instead of dropping a load on someone. The simulation reproduces the hazards that cause rigging fatalities: a load drop from sling failure, an incorrect sling angle that multiplies the tension and overloads the gear, an unbalanced or shifting load that swings or topples, and the struck-by that follows when people stand in the path of a swinging load. Inside the headset the worker estimates the load and finds its centre of gravity, selects and inspects slings and lifting gear, rigs with the correct angle and edge protection, performs a trial-lift to check stability, and guides the load to a safe landing. Because rigging depends on weight, angle and balance all being right together, the headset trains that judgement hands-on.

Rigging is unforgiving because the consequence of a poor rig is a load in the air over people. India's framework treats it seriously: the Factories Act 1948 carries explicit duties for lifting machines and lifting tackle, including periodic examination, under Section 29, the Building and Other Construction Workers Act 1996 extends protection across the construction sites where so much rigging happens, and a site lifting plan governs each lift. The common failure is not a lack of knowledge but a sling chosen by eye for a load no one weighed, an angle taken too sharp because the gear was short, or a worn sling reused because inspection was skipped. A classroom cannot let a rigger feel a sling part under tension; DrillXR lets them make and correct those mistakes in a virtual yard where the only cost is a lower score.