Hand & Finger Injury Prevention VR training for steel in Bengaluru.

DrillXR Hand and Finger Injury Prevention trains against the most common and most preventable category of industrial injury, the crushed finger, the de-gloved hand, the laceration that comes from a moment of inattention. The simulation reproduces the failures that put hands at risk: pinch points and crush injuries between moving parts, hands placed in the line of fire of a tool or load, cuts and lacerations from sharp edges and materials, and the wrong gloves, or no gloves, for the task. Inside the headset the worker identifies pinch points and the line of fire, selects gloves matched to the hazard, keeps their hands clear and uses the right tools, uses push sticks and jigs where required, and inspects gloves and reports near-misses. Because hand injuries come from habit and inattention, the headset is built to retrain where hands go.

Hand and finger injuries dominate the injury statistics on most production floors, and they are almost always the result of a hand placed where it should not have been. The Factories Act 1948 carries duties around the fencing of machinery and the provision of protective equipment, the Building and Other Construction Workers Act 1996 addresses hand protection on construction sites, and a site hand-safety and occupational health and safety plan defines glove selection, guarding and safe tool use. The common failure is not ignorance but familiarity, reaching into a pinch point to nudge a part, holding work by hand at a saw, or grabbing the wrong gloves because they were closest. A classroom cannot retrain instinct. DrillXR lets a worker place their hand in the line of fire in simulation and feel the consequence, building the keep-hands-clear habit safely.